Walls in older Tinton Falls homes: plaster, early board and settling
Most houses in Tinton Falls are not old. The Census Bureau's 2019–2023 survey puts the median year built at 1992. Still, about 2,100 of the borough's 9,095 homes were built before 1980, and 568 before 1950. Those older houses have walls that behave differently from the drywall in a 1990s townhouse, and they are repaired differently too.
What were walls made of before modern drywall?
Until the middle of the twentieth century, most interior walls were plaster on lath. Thin wood strips, the lath, were nailed across the studs with small gaps between them. Wet plaster was pushed through the gaps, where it curled behind the lath and hardened into "keys" that held the wall on. Two or three coats followed, ending with a hard, smooth finish coat. The result is dense, heavy and about an inch thick.
Later houses used gypsum lath, which is small panels of gypsum board with plaster applied over them, and then plain gypsum board with taped joints. Early board was sometimes 3/8 inch thick, thinner than the half-inch standard that followed. When a piece of new board is set into an old wall, the thickness difference has to be shimmed out or built up with compound.
Why do older walls crack the way they do?
Plaster is rigid. When a house settles, plaster does not flex at a seam the way taped board does; it cracks through. Typical patterns are long cracks running diagonally from door and window corners, cracks across ceilings, and a network of fine lines where the plaster has separated from the lath. That last one is the important sign. If a section of ceiling plaster moves when pressed gently, the keys have broken and the plaster is held up only by its own edges.
Settling cracks in a house that has stood for decades are usually old and stable. A crack that keeps widening, a door that has started to bind, or a floor that slopes noticeably more than it used to points to movement that should be looked at before any wall work.
Plaster that has let go of the lath
Loose plaster is reattached rather than replaced where possible. Washered screws or plaster anchors pull the plaster back against the lath, and an adhesive can be injected behind it. The cracks are then taped and coated. Where the plaster is beyond saving, it is removed down to the framing and the opening is filled with board built out to the plaster's depth.
Cracks in sound plaster
A crack in plaster that is still firmly attached is opened slightly, bridged with fiberglass mesh tape, and covered with a setting compound, which is harder than premixed joint compound and closer to plaster in strength. Premixed compound alone shrinks and cracks again over a plaster crack.
How is paint handled in a house built before 1978?
Lead-based paint was banned for home use in 1978. Older layers under newer paint may still contain it. Repairs on those walls avoid dry sanding of the old paint, use wet methods and plastic sheeting to keep dust in the work area, and clean up with a HEPA vacuum. Owners who want certainty can have the paint tested before the job.
How do repairs differ from those on newer drywall?
- Material: setting compounds and mesh in place of premixed compound and paper tape alone.
- Thickness: new board is shimmed or built up to meet plaster or early board.
- Time: setting compounds work in one visit but need care; built-up repairs need more coats.
- Finish: hard plaster takes paint differently from compound, so primer matters even more.
For crack work on any wall type, see the page on repairing cracks in walls and ceilings. The full set of guides is on the care guides index.